Silistretcher vs Stealth Stretcher?

How tedious is it to take on and off to go to the bathroom?
I wouldn't say its tedious, but definitely going to want to use a stall not a urinal. I fold the portion of sleeve that connects to the vaccum bell up over the top of the bell and leave the sleeve that I use on my penis on since I fit it to just below my glans.

That releases the vacuum within a few seconds, then once done peeing I can reinsert and fold back down the other sleeve and reapply some vaccum pretty quick.
 
I wouldn't say its tedious, but definitely going to want to use a stall not a urinal. I fold the portion of sleeve that connects to the vaccum bell up over the top of the bell and leave the sleeve that I use on my penis on since I fit it to just below my glans.

That releases the vacuum within a few seconds, then once done peeing I can reinsert and fold back down the other sleeve and reapply some vaccum pretty quick.
So you wear a sleeve, then roll one over the bell to seal on the shaft?
 
So you wear a sleeve, then roll one over the bell to seal on the shaft?
Yes. You simply turn 0.5 turn to release the pressure first, roll/fold the portion that goes over the vacuum cup/bell down to the penis, remove the cup/bell, pee, remove excess urine by doing a quick jelq/tinkle, shove the cup/bell back on, roll/fold the sleeve onto the cup/bell, turn 0.5 turn to increase the pressure, and ready to roll again. It will take a bit of practice.

However, brother ManPlan86 pointed out a key point about not using the urinal when you first start out. Why? When you use the sleeve, your penis will be compressed to some degrees, which means your urethra is also being compressed. When that happens, you create a scattered or focused urine stream. Imagine the scattered/focused stream making a nice little mess on your pants. Just something to adjust to until you get a hang of it. I can use the urinal now with pretty fast actions. The penis sleeve can give me griefs at time when I use dual layering of penis sleeve on days I perform quite active field acitivities. The dual layering of the sleeves allow the tension of the sleeves from slipping off the cup/bell without increasing further vacuum pressure. You don't want that sudden surge of traction pressure because it can create blisters. 0.5 turn equals to around 3 to 4inHg. A surge of pressure can go straight past 10inHg without you knowing. Those who twist a full to 1.5 turns, the pressure can exceed 20inHg without knowing.
 
So you wear a sleeve, then roll one over the bell to seal on the shaft?
Yah, let me try to explain better.

First I get myself a little aroused and then put on a sleeve on just my penis. It's a normal sleeve not one that looks like a condom, so my glans is exposed and not covered.

There is another sleeve on the bell, and I use my fingers to roll it back to the bell and flip it over the edge of the bell so I can squeeze my glans in. When doing this I make sure my glans is fully inside the bell, but not pushed so far in that it creates a big air pocket.

Once my glans is in, I unroll the sleeve from the bell down the shaft and it goes down the shaft a couple inches. At this point there is already a pretty good vacuum, but I still turn the screw on the bell a half turn or so.

Removing is the opposite. I have a couple pics in my progress album, just didnt want to include a pic of my dick here on your prog log.
 
It really takes no time to remove and put back on. It is very comfortable and can be used in any movement. Most wear all day. It can be used at higher tension for growth and lower intensity for cementing. A great buy!
 
Back
Top Bottom